Speaker Enclosure Planning Tool

Drag the baffle and depth sliders to see internal volume, the standing waves each inside dimension creates, how those modes are spread, baffle step, and the estimated panel resonances.

Net volume–
Vs target–
Mode spread–
Net internal volume–
Versus target–
Mode spread–
Baffle step–

Enclosure

Outside size to scale. The dashed line on the front marks the wall thickness, and the circle is the driver.

Inside proportions

Internal dimensions, smallest set to 1. Ratios near a whole number (1 : 1, 1 : 2, 1 : 3) put standing waves from two dimensions on the same frequency.

–

Standing waves inside the box

Width modes Height modes Depth modes
  • Red ring: modes from two dimensions within 3% of each other. They add together and get louder.
  • Shaded area: outside your driver’s crossover range. The driver barely plays there, so modes in it matter little.

Axial modes by dimension

The strongest standing waves for each inside dimension, and how hard your driver excites each one from where it sits. Set the driver position under Driver.

DimensionInside1st mode2nd mode3rd mode
  • % driven: 0% means the driver sits where that mode’s pressure stays still, so it barely excites it. 100% means it sits where the pressure swings hardest.
  • Depth modes always show 100%, because the driver is mounted on the baffle, where every depth mode’s pressure peaks.
  • Above or below crossover: the mode is outside your driver’s crossover range, so the driver barely reaches it.
  • A red frequency stacks with a mode from another dimension, matching the red rings in the chart.

Panel resonances

Estimated lowest vibration frequency of each unsupported panel, for your sheet material and thickness. Driver cut-outs weaken the baffle, so its real resonance can be lower than shown.

Unbraced, coloured by status One brace across the middle Two braces, at thirds
PanelUnsupported spanThicknessUnbraced1 brace2 bracesStatus
  • Brace recommendedResonates inside your driver’s crossover range, so it can ring along with the music. Add a brace across the long span, or use thicker or stiffer sheet.
  • Above or below driver rangeResonates outside your driver’s crossover range, so the driver barely excites it.

What to watch

Checks recalculated from your current dimensions.

    How it’s calculated

    Inside size: W − 2t, H − 2t, D − tbaffle − t.

    Speed of sound: c = 343.4 m/s, for air at 20 °C.

    Axial standing wave along one inside length L: f = n × c / (2L), n = 1, 2, 3…

    All modes, including tangential and oblique: f = c/2 × √((nx/Lx)² + (ny/Ly)² + (nz/Lz)²).

    Driver excitation for mode n: the average of cos(nπx / L) across the cone, taken as 80% of the frame diameter, with x measured from the inside face of the bottom or left wall.

    Baffle step centre: f ≈ 115 / W, with W the outside baffle width in metres.

    Panel resonance, simply supported plate (a conservative estimate; glued edges and cleats push it higher, driver cut-outs pull a baffle lower): f = π/2 × √(D / ρh) × (1/a² + 1/b²), with D = E h³ / 12(1 − ν²).

    The mode-spread rating is a rule of thumb: it penalises inside dimensions within 10% of each other or close to 2× or 3× another, and weighs how closely the lower axial modes from different dimensions coincide inside your driver’s crossover range.